Abstract:
In this study, a simple device was designed and developed
to to measure the
critical load to produce buckling of large wooden samples. Using this
device, the required critical load to produce buckling was analyzed for
Coconut and Palmyra trees. The actual load acting on the selected Coconut
trunk was measured as 1059.48 N and the estimated critical load is 1536.72
N . On the other hand, the critical load to bend the Palmyra trunk was
determined as 12734.10 N , while the actual load acting on that Palmyra
trunk was measured as just 2656.55 N . The ratio between the a ctual load
and critical load for bending in coconut tree is about 1:1.5 while the same
ratio is about 1:5 in Palmyra tree. The ratios from the study gives a reason
for this observed buckled shape of Coconut tree and Palmyra trees grown in
the nature. Furt her, the same device was used to measure the Young’s
modulus of the wooden trunks. The average values for the Young’s modulus
of the selected Coconut and Palmyra trunks were determined as 8.01×10 8 (±
2.47 x10 8 Nm 2 and 22.16×10 8 (± 3.90 x10 8 ) Nm 2 respect ively. Highest
young’s modulus and buckling coefficient of the Palmyra tree made it as the
most suitable material for construction work.
